Flat Parts Photo Etching Design Guide
All dimensions, tolerances and configurations are functions of the thickness of the material being photo etched and should be considered during the design process. The following guide gives practical limitations for slots, spaces, holes and construction dimensions with relation to metal thickness for photo chemical milling. (See Figures 1 and 2 for a representation of the features referenced.)
In many cases it may be possible to exceed these photo etching limitations, but with a reduction in yield percentage. Consult the factory for design assistance when these situations occur.
DIMENSIONS
HOLES / SLOTS
Generally, the diameter of a hole or the width of a slot cannot be less than the metal thickness. This relationship varies as the metal thickness changes. A more exact relationship is illustrated in Table 1.
Table 1. HOLES OR SLOTS |
|
Metal Thickness (T) |
Diameter or Width |
.001″-.005″ |
At Least Metal Thickness, Min. .003″ |
.005″ or Over |
Min. of 1.1 Times Metal Thickness |
INSIDE CORNER RADIUS
The smallest inside corner radius is directly proportional to the metal thickness. *Consult our sales staff if a smaller or sharp radius is required.
FINGERS / WEBS
Generally, the width of a finger or web cannot be less than the metal thickness. This relationship varies as the metal thickness changes. A more exact relationship is illustrated in Table 2.
Table 2. WEB OR FINGER |
|
Thickness (T) |
Spaces Between Holes (W) |
Less than .005″ |
At Least Metal Thickness, Min. .003″ |
Over .005″ |
Min. of 1.25 Times Metal Thickness |
OUTSIDE CORNER RADIUS
The outside corner radius will be at least .75 of the material thickness.
TOLERANCES
CENTER TO CENTER
Generally, the tolerances are a result of the stability of the photo tooling material. Table 3 illustrates the practical tolerances attainable from industry standard Mylar tooling. Consult our sales staff for information on alternate tooling materials.
Table 3. CENTER TO CENTER TOLERANCES |
|
C/C Dimensions (inches) |
Tolerance Attainable |
1.0″ or Less |
±.0005″ |
1.0″ – 6.0″ |
±.0010″ |
6.0″ – 12.0″ |
±.0015″ |
12.0″ – 24.0″ |
±.0020″ |
PHOTO ETCHED DIMENSIONS
Generally, a tolerance of ± 15% of the material thickness is practical. A more exact relationship is illustrated in Table 4.
Table 4. ETCHED DIMENSION TOLERANCES |
||||||
Thickness |
||||||
.001″ |
.002″ |
.005″ |
.010″ |
.015″ |
.020″ |
.040″ |
Empirical |
±.0010″ |
±.0010″ |
±.0015″ |
±.0020″ |
±.0030″ |
±.0050″ |